Adept Rocketry - Accessories - VCK2 Vacuum Chamber

Test your altimeters, altimeters with deployment outputs, Apogee Detectors™, and On-Board Computers under simulated flight conditions up to several thousand feet. The VCK2 Vacuum Chamber includes a length of tubing for pulling a vacuum, and a specially sealed cable for connecting to test deployment charges, small lightbulbs, and so on. The VCK2-S includes a calibrated 60cc syringe (as shown here).

The cable allows lightbulbs (or even actual test charges used with caution) to be fired outside the Vacuum Chamber bottle where they cannot affect the inside pressure in any way. Simply plug the altimeter device onto the cable and let it hang from the cap, inside the 500cc laboratory grade bottle. For an altimeter without deployment outputs, simply place it inside the bottle.

The VCK2 and VCK2-S are equipped with a specially sealed CAB6-12 (non-locking) cable and a tube for pulling a vacuum. It is a complete unit including the bottle. Use the VCK2 and VCK2-S with the ALTS1, ALTS2, ALTS20, ALTS25, APD1, DCS1, DDCS2, RA2, RAS2, and OBC2. It also may be used with any other altimeter device that will fit inside it. The 6-wire cable may be used with any of the devices that have a 6-pin connector, a 5-pin connector, or a 2-pin connector. Note: the VCK2 is not large enough to accept the ALTS82 Maximum Altitude Altimeter with Dual Deployment™ or RA3 Recording Altimeter™ with Display.

VCK2-S Vacuum Chamber, complete with Syringe: $24.95

VCK2 Vacuum Chamber, without Syringe: $19.95

60CC-Syringe 60cc Syringe Only: $5.95

VACBOT-2 Same as VCK2-S, but without the Cable: $16.79

Selection

www.adeptrocketry.com      5/30/14


Copyright © 1989-2014, All Rights Reserved