Dual (Two-Event) Staging / Deployment Timer
ST236LH Dual (Two-Event) Staging / Deployment Timer
ST236H Dual (Two-Event) Staging / Deployment Timer
The two-event ST236 Staging / Deployment Timer is capable of supplying very high current to igniters or deployment charges. It arms at the first instant of liftoff, and each output fires individually after predetermined periods of time. It may be used for staging multi-stage rockets, air starting motors, or for controlling parachute deployment at a given time(s) after liftoff. The Timer can also drive or furnish power to other types of electrical or electronic devices. It may be used for combinations of sequential ignition, staging, multi-event deployment (Dual Deployment™), etc.
The ST236 Timer is offered in two different configurations with different current supplying capabilities. The model designations are ST236LH and ST236H. The ST236LH is pictured above. The ST236H can be identified by the absence of a couple of components, the large blue capacitor above the right end of the battery holder is missing, and the legend "EXTERNAL BATTERY REQUIRED" is visible. Also missing on the ST236H, the small 2-pin connector just below the red 6-pin connector. Both models are capable of supplying high current (up to 12 amps of current) when used with an external battery, to fire virtually any type of igniters or deployment charges, depending on the type of load driving battery used, alkaline, nicad, etc. The designation LH stands for low current or high current. When used for low current the ST236LH device does not need an external battery. The small on-board battery along with the large electrolytic capacitor are used to fire flashbulbs or low-current electric matches such as the Davey Fire brand 28B or 28BR electric match. When used for high current, the LH device requires use of an external battery. The ST236H device (lowest cost) always requires use of an external battery even if used to fire only low-current igniters or deployment charges.
A 12-volt lighter battery is used to keep the microprocessor system running glitch free during the times of heavy current demand on external load-driving batteries. Current to a low-current load is actually supplied by the large electrolytic capacitor on the ST236LH. The lighter battery is always used, even when an external battery is required. Times are programmable to values in excess of 10 minutes in increments as fine as 1/100 second. The length of time in which the outputs remain energized is also programmable. Programmed settings are nonvolatile, and they are not affected when the device is turned off or when the batteries are removed. The settings remain indefinitely until they are reprogrammed.
The outputs may be used to drive light bulbs, or electric motors for functions of a mechanical nature. They can also be used to furnish power to other electric or electronic devices, with fully programmable on-times and off-times. Programming and testing is simple and quick. The ST236 uses Adept’s patented acceleration sensing system ("A" Switch™) for simplicity and to insure safety. If acceleration and movement upward does not continue for at least 0.3 second, the timeout operations will not be enabled. The system cannot be set off accidentally by dropping, shaking, bumping, falling over, etc. Times start from the first moment of liftoff.
This microprocessor based device measures 1.4" wide by 0.65" thick by 3" long. It fits in a tube with a minimum ID of 1.5 inches (38 mm). It will also fit on either side of a center plate inside a 54 mm ID bay, three inches long. Its weight with battery installed is only 1.2 ounces. An Adept CAB6L-xx series Interconnect Cable Assembly (or CAB6BC) is used to control power, and for igniter (or deployment charge) connection. Included is circuitry to detect and separately indicate when the igniters have continuity. The battery life for this product is many hours, so you need not be concerned about how long your rocket sits on the launch pad after being connected to igniters and powered up.
Additional CAB6BC Cable/Battery Clip Assembly Kit
CAB6L-24 Interconnect Cable
CAB2-12D - 12-inch CAB2-12
Interconnect Cable with 12-inch Disconnect Leads
Additional GP-23A Alkaline Lighter Battery - Price: $2.25
GP-23A50 Alkaline Lighter Batteries (box of 50 at 50% Discount) - Price: $56.25
The GE/Sanyo 9 volt size nicad batteries are made with cylindrical cells and have very low internal resistance. They can supply up to 15 Amps of current for short periods, making them ideal for many rocketry uses.
N-6PT GE/Sanyo 9 Volt Size Rechargeable Nicad Battery - Price: $16.79 out of stock
BC1 Premium Battery Clip for 9 Volt Size Battery (6-inch leads) - Price: $1.15
WY-29V Charger for Two 9 Volt Size Nicad Batteries (plugs into wall socket) - Price: $14.50
Shorting Jumpers are used on some devices to program certain values or functions. One Jumper is used on the ST236LH when it is used without an External Battery in Low Current Mode.
Shorting Jumpers - Price: $1.39 per pack of 10.
Electronic Instrumentation is not compatible with the fumes and residue created by rocket motors and deployment charges. Seal holes and gaps in bulkheads and such with epoxy or removable putty.
The ST236 is also available in another form as the ES236 Dual Sequential Stager™. Unlike a Dual Timer, a Dual Sequential Stager™ detects liftoff by first detecting acceleration, and then fires the second stage when it detects deceleration of the first stage due to motor burnout. This is especially handy when the exact burn time of the first stage motor is not known, as with a hybrid motor. Also, an amount of coast time may be added before ignition of the second stage. Then if the second stage properly ignites and properly accelerates, the third stage ignites on burnout (deceleration) of the second stage. And again an amount of coast time may be added before ignition of the third stage. An Electronic Stager™ or Dual Sequential Stager™ can also be used to control air-start sequencing of motors.
ES236LH Dual Sequential Stager™
ES236H Dual Sequential Stager™
Copyright © 1993-2003, All Rights Reserved